Data & Methodology — Jefferson County

Full contaminant data, sample history, and sourcing for Jefferson County. For readers who want to go beyond the summary.

Contaminant Data — All Analytes

108 well testing events on record, covering 21 analytes. Data spans 1956 to 2024.

Contaminant Samples Years Detection Rate Distribution LowModHigh vs. Limit vs. FL Avg
Iron 56 1982–2025 98%
66% of limit ↓ 67% below
Manganese 56 1982–2025 98%
41% of limit ↑ 54% above
Arsenic 55 2017–2025 100%
5% of limit ↓ 62% below
Chloride 105 1982–2025 100%
2% of limit ↓ 96% below
PFNA municipal 6 2023 0%
— —
PFOA municipal 6 2023 0%
— —
Nitrate 48 2023–2025 100%
2% of limit ↓ 35% below
PFHxS municipal 6 2023 0%
— —
PFOS municipal 6 2023 0%
— —
Fluoride 105 1982–2025 100%
4% of limit ↓ 44% below
HFPO-DA (GenX) municipal 6 2023 0%
— —
Nitrite 48 2023–2025 100%
3% of limit ↑ 143% above
Lead 55 2017–2025 100%
1% of limit ↓ 81% below
Sulfate 105 1982–2025 100%
1% of limit ↓ 95% below
Sodium 103 1982–2025 100%
— ↓ 95% below
pH 105 1982–2025 100%
— ~ typical
PFBS municipal 6 2023 0%
— —
E. coli 7 2022–2025 100%
— ~ typical
Fecal Coliform 12 2017–2020 100%
— ~ typical
Hardness 2 1982–1999 100%
— ~ typical
Total Coliform 19 2017–2025 100%
— ~ typical

Distribution shows the share of samples in each concentration band relative to the EPA Maximum Contaminant Level (MCL): Low = below half the MCL, Moderate = between half and the MCL, High = above the MCL. Analytes without an MCL (e.g. sodium, pH) show — in the limit columns. State average is based on county median values across FL.

Compare your result with Jefferson County

Of the 55 arsenic tests on record for Jefferson County (2017–2025), 0% found none, and half were below 0.5 µg/L.

Of the 105 chloride tests on record for Jefferson County (1982–2025), 0% found none, and half were below 4.73 mg/L.

Of the 105 fluoride tests on record for Jefferson County (1982–2025), 0% found none, and half were below 160 µg/L.

Of the 56 iron tests on record for Jefferson County (1982–2025), 2% found none, and half were below 194 µg/L.

Of the 55 lead tests on record for Jefferson County (2017–2025), 0% found none, and half were below 88 ng/L.

Of the 56 manganese tests on record for Jefferson County (1982–2025), 2% found none, and half were below 19.7 µg/L.

Of the 48 nitrate tests on record for Jefferson County (2023–2025), 0% found none, and half were below 210 µg/L.

Of the 105 sulfate tests on record for Jefferson County (1982–2025), 0% found none, and half were below 3.1 mg/L.

Have a number from your lab? Enter it to see where it falls. Nothing is sent anywhere.

Want the full picture for your well? Check all your results.

Data Coverage & Gaps

Well-sampled analytes (15+ samples)

  • Iron 56 samples
  • Manganese 56 samples
  • Arsenic 55 samples
  • Chloride 105 samples
  • Nitrate 48 samples
  • Fluoride 105 samples
  • Nitrite 48 samples
  • Lead 55 samples
  • Sulfate 105 samples
  • Sodium 103 samples
  • pH 105 samples
  • Total Coliform 19 samples

Limited data (<15 samples) — interpret with caution

  • E. coli 7 samples
  • Fecal Coliform 12 samples
  • Hardness 2 samples

No private-well PFAS data for Jefferson County

We have no private well sampling data for PFAS compounds (PFOA, PFOS, PFNA, and related chemicals) in Jefferson County. PFAS testing for private wells requires a dedicated lab panel (~$300–$500). If you are near a military base, airport, or industrial site, consider testing proactively. Learn more about PFAS →

Public vs. Private Water in Jefferson County

12 Active public water systems
10,255 Residents on public water
63% Households on private wells

Public water systems in Jefferson County are regulated by the EPA and must test and report contaminant levels. Private well owners are responsible for their own testing — there is no routine monitoring of private wells by any government agency.

Data Sources

This report aggregates data from the following public databases:

Methodology

Raw records are downloaded from the Water Quality Portal and normalized to µg/L (ppb). Records are deduplicated by sample ID and date, and certified outliers are excluded. Analyte names are mapped to EPA canonical forms. Detection rates, distribution bands, and MCL comparisons are computed from the normalized dataset.

Distribution bands use the EPA Maximum Contaminant Level as the threshold: concentrations below 50% of the MCL are classed as Low, between 50% and 100% as Moderate, and above 100% as High. For analytes without an MCL (sodium, hardness, pH), distribution is not computed.

State comparison uses the median of county median values across all counties in FL with at least one sample for that analyte.

Last updated: 2026-08-12

Full methodology →